Ford Powerstroke MAP Dual Boost Relief Valve++ 7.3L 6.0L Boost fooler

Ford Powerstroke MAP Dual Boost Relief Valve++ from DFUSER
_[DRV++]

$39.00

Prevents the SES light from activating at boost levels over 25-26 PSI and prevents the engine from defueling from "excess boost".
Similar to a BOOST FOOLER, this item prevents the service engine light from setting off at higher than stock boost levels.
This mechanical device is intended to be installed between the MAP sensor and the intake manifold on all Fords 7.3L Turbo Diesel.
Fits all 7.3L & 6.0L trucks, 1999+ with MAP sensors.
This device allows any boost pressures above 22PSI to be released so that the SES light is not set and the MAP sensor does not send signal to the PCM to go in to a defueling mode, if you are running high boost, typically found on aftermarket High Performance chips and programs.
The boost gauge through this connection will now only read a max of 22- 25lbs. The truck may actually go much higher if you are running an 80+ hp chip. To read boost above 22-25 lbs you must tap into the aluminum intake air horn, or buy our Air Intake Heater Eliminator with Boost fitting for 99.5 - 2003 7.3L.
1994-1997 trucks set an overboost code at 14-17lbs, we now offer a DRV set up for these trucks, select the dropdown below.
LIFETIME WARRANTY!

Click here for install instructions

Available Options:
Year:

This product was added to our catalog on Saturday 04 February, 2006.

Quantity:

Customers who bought this product also purchased

1994-1997 Ford AFE Stage 2 Intake Pre Filter BLUE	4 Inch Inlet 4 Inch Outlet Stainless Clamp-On Slash Cut Exhaust Tip
Fuel Filter 1994-1997 7.3L Ford Powerstroke Diesel F250/F350	94-03 Ford 7.3L Powerstroke Tag Turbo Air Guide 1 & 2 Combo
5" Dual Chrome Diesel Pickup Truck Smoke Stack Kit	1994-1997 Ford Powerstroke Three Inch Aluminized Steel Down Pipe